johntwo
11-07-2007, 09:18 AM
i have two files, saved in INsignia, one with a bridge and the other without the bridge. I realize that with the bridge the machine goes up to 1.5 without it it does not. It was saved as shopbot inch arch. anyone now about this issue.
there was another problem but i think that i solved. It went down into the spoil board but I change the speed to .50 on Z and i beleive the bit is dull or was not tight.
there was another problem but i think that i solved. It went down into the spoil board but I change the speed to .50 on Z and i beleive the bit is dull or was not tight.