Cardholder design

[myxpykalix]

Here is a design for a cardholder I want to make but not sure if there is a better way to do this.
I want to make it so that (as in the side view) the front slants down so that i can carve something in that space. My thought was to cut the slant on the tablesaw, then cut a corresponding angle wedge. mount the wedge and holder in a jig to hold it 90 degrees to the bit so i could carve on the flat surface. Am I on the right track or is there an easier way to do this? thanks

9128

[sawdust535]

Jack, I have an idea that might work. Do you have CorelDraw so I can send you a cdr file?

[myxpykalix]

I don't have it but i think i can have it converted. Can you make it as a dxf? Send what ever you have, thank you!

[sawdust535]

I e-mailed you a dxf. I have a problem getting files under 50k to post on here.

[myxpykalix]

I got it and replied, thank you...