knight_toolworks
06-29-2008, 02:07 AM
This project was a little bit of a challenge. The hardest part was getting the text to work right. I could copy and paste the text just fine with all of the special marks in place. But once you made the text most of the items vanished. I had to change the language for non Unicode to Romanian and reboot to get it to work. Then all the special symbols would work. But he wanted a regular comma under the s so I had to change them manually.
I created the olive branches out of a imported jpeg and cut and pasted to get that shape. These will have an ogee edge rather then a frame. I did the painting and the glazes so don’t ask me about it.
Hopefully he can peddle them and I can make them on a regular basis. I just did the 10 commandments today but it’s hard to get a good picture till it is painted. this was done on mdf with a 60 v using vcarve pro on my shopbot. Took about 45 minutes to cut.
here is a link to a better copy
http://i154.photobucket.com/albums/s266/knighttoolworks/vcarving/P1000718.jpg
2075
I created the olive branches out of a imported jpeg and cut and pasted to get that shape. These will have an ogee edge rather then a frame. I did the painting and the glazes so don’t ask me about it.
Hopefully he can peddle them and I can make them on a regular basis. I just did the 10 commandments today but it’s hard to get a good picture till it is painted. this was done on mdf with a 60 v using vcarve pro on my shopbot. Took about 45 minutes to cut.
here is a link to a better copy
http://i154.photobucket.com/albums/s266/knighttoolworks/vcarving/P1000718.jpg
2075