View Full Version : moose and leaf plaque
steve
03-30-2010, 05:23 PM
This is about 12 x12", background is cherry, moose is walnut. About 8 hours cutting, last toolpath was a 1/8" tapered ballnose.
This was desgined by (and cut for) Todd Bailey at 4m3D Creative Design.
www.4m3d.com (http://www.4m3d.com/)
fredtoo
03-30-2010, 06:32 PM
Nice, I like it!
myxpykalix
03-30-2010, 06:58 PM
Stephen did you inlay that somehow or just glue it together? So we see you can do more then just cool turnings! good job!
steve
03-31-2010, 06:24 AM
hi Jack, I glued them together after cutting, had to clean up the edges. Next time I might try gluing the two pieces of wood togethet before I cut them.
Stephen,
Great job! I like the wood contrast - a lot of projects I do are based on contrasting woods.
The moose model is really good. Is that available for purchase by any chance?
steve
03-31-2010, 05:57 PM
Don, you would have to contact Todd Bailey at 4m3D Creative Design.
www.4m3d.com (http://www.4m3d.com/). The model belongs to him.
Thank you Stephen.
I will contact Todd.
Again, great job!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.