PDA

View Full Version : rocking chair cut file



ttwark
04-17-2010, 11:44 AM
Good morning, Shopbot has used a small rocking chair cut file to demonstrate its cutting before. I have looked but can't find this posted anywhere and wondered if someone could direct me to the proper area where I might find this cut file if it is available. Thanks, Deb (Tom's wife)

gc3
04-17-2010, 06:39 PM
There are a couple crv files posted on the v carve pro forum

www.vectric.com (http://www.vectric.com)

don
04-20-2010, 11:16 PM
Here is the thread on vectric site that has a couple of a knockdown chair and a rocker (http://www.vectric.com/forum/viewtopic.php?t=444&postdays=0&postorder=asc&start=180).
Forth and Fifth post on the page in the link.
Hope this helps

ttwark
04-21-2010, 10:11 AM
Thanks, guys! Deb (Tom's wife, who loves to use his Shopbot!)