gripus
06-01-2010, 02:46 PM
I am not new to CNC but I am quite new to ShopBot (PRT 60X120). I have a file that is nothing but straight line cuts with a 90 degree V-bit in a sheet of plywood.The project was done in Aspire and consists of a separate toolpath for each cut. The reason for that is I wanted the econmy of motion of selecting the startpoints for each cut.
The file ran for a little over 3 minutes (32 lines of code) and stopped in mid cut. There was no error message, the cursor would not move and the little hourglass was showing. The only way I could get out of that was to re-start the computer.
I have attached the file if one of you ShopBot Wizards would take a look at it I would appreciate it.
Regards,
Joe
The file ran for a little over 3 minutes (32 lines of code) and stopped in mid cut. There was no error message, the cursor would not move and the little hourglass was showing. The only way I could get out of that was to re-start the computer.
I have attached the file if one of you ShopBot Wizards would take a look at it I would appreciate it.
Regards,
Joe