View Full Version : Pre alpha control boards
Can anyone tell me the difference if any between control board V3.40 and V3.54. Both use 3.4.27 control software.
Thanks
Gene
http://cgi.ebay.com/TB6560-Driver-4Software-OTHER-than-MACH-3-stepper-motor-/290442771816?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item439fbcfd68
Any thoughts on using this as a driver board with the newer versions of Shopbot control software...for a older PR with PRT motors.
Gene
Can anyone tell me the difference if any between control board V3.40 and V3.54. Both use 3.4.27 control software.
Thanks
Gene
So maybe it's my imagination but the machine runs much smoother with the 3.54 board. For a vintage PR machine, to run at 6IPS Jog(max with 3.4.27) And cut .75 ply with 2 pass, ok laugh, at 4.5 ips...plus a 35% increase in 3D carve speeds...
Well one day I will have fun with a Alpha machine...
Thx
Gene
http://cgi.ebay.com/TB6560-Driver-4Software-OTHER-than-MACH-3-stepper-motor-/290442771816?cmd=ViewItem&pt=LH_DefaultDomain_0&hash=item439fbcfd68
Any thoughts on using this as a driver board with the newer versions of Shopbot control software...for a older PR with PRT motors.
Gene
I am looking at using the V201 card with the driver board linked above...approx cost for this possible upgrade $600USD.
Opinions/advice please.
Thx
Gene
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.