SB3 Control Software

[jimboy]

I have a PRS Buddy 48 and I am running SB3 version 3.5.15. I have tried later versions with no luck and I was wondering if anyone has had experience with the latest 3.6.18 version. What are any probs or issues?

Thanks Jim :confused:

[ed_lang]

I am running the 3.6.18 without any problems. I am running on a PRSalpha 48 machine.

I upgraded from the very reliable (in my opinion) 3.5.20.

[Gary Campbell]

I'm with Ed... 3.6.18 is good

[jimboy]

Thank you Ed and Gary for your prompt reply. I just hated to jump in without asking someone. I tried upgrading a couple of version up from 3.5.15 without any success. I'll give it a try...Fingers crossed. Just kidding - :D
Jim