artbot
07-13-2010, 01:20 PM
hey guys,
new to the shopbot forum. i am a print maker so i only use my shopbot about twice a year. but i have just got word that my board has two bad "cards" (the small cards that control each axis). the repair is beyond my means at the moment. but i need it to work immediately for a few orders.
is there any board repair person, or does anyone one have an old pre-4g board that some cards can be salvaged from? or can aftermarket 5 axis controller board kits be used for this machine? i've seen entire 5 axis controllers, plus 5 new motors are available.
thank you for any help you can provide.
attached is a pic of the board needing repaired.
new to the shopbot forum. i am a print maker so i only use my shopbot about twice a year. but i have just got word that my board has two bad "cards" (the small cards that control each axis). the repair is beyond my means at the moment. but i need it to work immediately for a few orders.
is there any board repair person, or does anyone one have an old pre-4g board that some cards can be salvaged from? or can aftermarket 5 axis controller board kits be used for this machine? i've seen entire 5 axis controllers, plus 5 new motors are available.
thank you for any help you can provide.
attached is a pic of the board needing repaired.