Converting cut files back to DXF

[nepenthes]

Somewhere on this forum there is a thread about converting a cut file back to a dxf file, but I can't find it anywhere. Can someone point me in the right direction?

[adrianm]

To convert an SBP file to DXF, use FC (File Conversion) from the control software and choose SBP files to DXF.

[jsooter]

I wasnt thinking about that but it is helpful info. I am sure I will want to now that I know.

[myxpykalix]

The last time i tried it it also translated the carriage movements from 0,0 as shown in this pic so you may need to do some editing to delete unwanted stuff.

[steve_g]

If your cut path is not full depth in one pass, it will also show as duplicate lines (on top of each other) that will need to be edited.

[srwtlc]

And, take into account the diameter of the tool used. Inside, outside, or on the line strategy.

[nepenthes]

Thanks. That is exactly what I was looking for.