meatbal80
08-26-2010, 02:15 PM
Had one of those thoughts while shaving :rolleyes:, has anyone at shop bot thought about adding the ctrl-z (undo) option to the control software.
For example:
Z axis just cut to deep, hit control-z and poof good as new. Now just fix the part file and run it again.
Or
Just cut out the right file on the wrong (generally more expensive, funny how it works out that way) material. Hit control-z pull the now unscathed sheet out and load the correct one and hit start.
What would you do with out dreams. But if someone could figure out how to do it sign me up.
For example:
Z axis just cut to deep, hit control-z and poof good as new. Now just fix the part file and run it again.
Or
Just cut out the right file on the wrong (generally more expensive, funny how it works out that way) material. Hit control-z pull the now unscathed sheet out and load the correct one and hit start.
What would you do with out dreams. But if someone could figure out how to do it sign me up.