View Full Version : Could have used that ctrl Z button
ken_rychlik
08-30-2010, 11:31 AM
Just when I thought I kind of knew what I was doing. that darn decimal point got me. Big difference between cutting .5 inches deep and 5 :eek:
All I could do was laugh.
Kenneth
curtiss
08-30-2010, 11:57 AM
Could Vectric add a warning such that "bit will cut through the material by over one DARN inch... are you sure or just crazy ??? :eek::eek::eek:
tony_mac
08-30-2010, 12:06 PM
Could Vectric add a warning such that "bit will cut through the material by over one DARN inch... are you sure or just crazy ??? :eek::eek::eek:
For reference - The Vectric software does display a Warning Message if the cut depth is greater than the material thickness - this usually catches this type of issue.
Tony
ken_rychlik
08-30-2010, 12:24 PM
Ya, I know it has that. I was cutting through a .48 thick piece so it was a through cut.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.