PDA

View Full Version : Up and running



ATX Poly Products
09-07-2010, 08:34 PM
Here are just a few pics from my first week with my SB...

Thanks

http://i157.photobucket.com/albums/t80/Adamtrax/ShopBotAssem116.jpg

http://i157.photobucket.com/albums/t80/Adamtrax/ShopBotAssem113.jpg

http://i157.photobucket.com/albums/t80/Adamtrax/ShopBotAssem121.jpg

http://i157.photobucket.com/albums/t80/Adamtrax/ShopBotAssem117.jpg

curtiss
09-08-2010, 10:23 AM
After over a year of "this bot sure is messy" I made an air deflector for the bottom of the PC router.

It came from a 5 inch diameter "plastic tire" that was a case for a Dale Ernhart race car. (gives the bot a sort of NASCAR look )

Cut a 1.75 in hole in the middle and with a little double sided tape, the dust collector now works much better as I am not trying to blow air down from above... no problem with wrenches.

jd9737
09-08-2010, 11:39 AM
I was just curious. What is the best way to remove tabs from polycarbonate?

Thanks, Bill

bleeth
09-08-2010, 01:36 PM
Don't know if they still have any of them around but some years back SB had the "official" deflector for PC routers.

myxpykalix
09-08-2010, 03:27 PM
I seem to recall a thread on this subject and I recall the cheapskates solution (my favorite) was the bottom cut out of a 2 liter pop bottle.:rolleyes:

rcnewcomb
09-09-2010, 12:09 PM
I used a deli container (http://talkshopbot.com/forum/showpost.php?p=71301&postcount=13).

Be sure to eat the potato salad first before attempting installation. ;)

bleeth
09-09-2010, 12:20 PM
Yeah-but did you use it by 1/05?

ATX Poly Products
09-27-2010, 06:34 PM
I was just curious. What is the best way to remove tabs from polycarbonate?

Thanks, Bill

How thick are you leaving your tabs?

I leave about 1/32" and nip them off with flush cut sidecutters. Works slick!

ATX Poly Products
09-27-2010, 06:35 PM
After over a year of "this bot sure is messy" I made an air deflector for the bottom of the PC router.

It came from a 5 inch diameter "plastic tire" that was a case for a Dale Ernhart race car. (gives the bot a sort of NASCAR look )

Cut a 1.75 in hole in the middle and with a little double sided tape, the dust collector now works much better as I am not trying to blow air down from above... no problem with wrenches.

Yes, the PC head does blow alot of chips around... I'll have to give this a try...

Does this limit the amount of air flow that cools the router?

Brady Watson
09-27-2010, 07:07 PM
I was just curious. What is the best way to remove tabs from polycarbonate?


The best way is to not use them at all! :D

Pursuant to that...Look at this (http://www.talkshopbot.com/forum/showthread.php?t=11481&highlight=vacuum+film)

-B

curtiss
09-27-2010, 10:35 PM
......Does this limit the amount of air flow that cools the router?

I think you will find you still have plenty of air movement, ....if not you may be blocking something

as stated, mine was shaped like a small tire which helps... (not shaped like a coffee can lid)