terryb
11-08-2010, 04:27 PM
Village Sign Works , puts down the paint brush for a day to fabricate parts for A
Non- Profit organization , was interesting to work on something other than signs.
Blackfoot CNC
all parts were fabricated from 1 8x10 sheet of 3/4 MDF, I used a Onsrud 60-110 single flute compression spiral end mill , which produce clean cuts and no blow out on both sides....nice bit work perfectly !
Artisan’s Asylum, Inc. is a non-profit community craft studio located near Union Square in Somerville, Massachusetts.
There mission is to support and promote the teaching, learning and practicing of craft of all varieties.
take Care,
Terry B
Village Sign Works
Non- Profit organization , was interesting to work on something other than signs.
Blackfoot CNC
all parts were fabricated from 1 8x10 sheet of 3/4 MDF, I used a Onsrud 60-110 single flute compression spiral end mill , which produce clean cuts and no blow out on both sides....nice bit work perfectly !
Artisan’s Asylum, Inc. is a non-profit community craft studio located near Union Square in Somerville, Massachusetts.
There mission is to support and promote the teaching, learning and practicing of craft of all varieties.
take Care,
Terry B
Village Sign Works