marcrunner
08-20-2009, 03:46 PM
Hello everyone,
I have an older PR96 that is finally up and running. I designed a part file using the part file editor, saved it, and tried to go back in under "File Load and Execute" to cut the file, but the file is not there? I tried to reboot the system thinking that would help. Is there something I am missing? Is there a prompt to go from editing to executing? I am trying to cut my custom vacuum table file. Thanx, Marc
I have an older PR96 that is finally up and running. I designed a part file using the part file editor, saved it, and tried to go back in under "File Load and Execute" to cut the file, but the file is not there? I tried to reboot the system thinking that would help. Is there something I am missing? Is there a prompt to go from editing to executing? I am trying to cut my custom vacuum table file. Thanx, Marc