Router/Slitter Supplier?

[Gary Campbell]

Sometime back I saw a post with a small slitter bit on an arbor. Anyone remember who/what where it can be found?

Needs to be a one piece shaft and blade, no nut or screw can protrude below the blade.

Any ideas? Thanks in advance, GC

[frank134]

not sure but try http://www.whitesiderouterbits.com/catalog.html they have a lot of different bits.

[waynelocke]

Was it the drag knife bit on the SB website which I think is from Widgetworks?

[Gary Campbell]

Frank...
Thanks but no joy.

Wayne....
Nope, but thanks. The "little saw" I am looking for looks like a Dremel disc on a shaft, except its a saw blade or slitter welded to the shaft. Capable of putting a narrow groove virtually on the bottom of a recess. The perfect one would have a 1/4 xhaft, 3/4 cutting diameter and be .065 thick.

I swore I saw a post with a pic of one some time ago.

[gc3]

http://cgi.ebay.com/New-Onsrud-1-Solid-Carbide-Trim-Blade-Flush-Mounted-/220712276549?pt=LH_DefaultDomain_0&hash=item33637a1245

[Gary Campbell]

Thanks Gene

[gc3]

Thanks Gene

Merry Christmas!

Familia Crain Gene, Terri, Fort and Ellie

[gc3]

Thanks Gene

will it meet your needs?

[Gary Campbell]

Gene...
Actually I needed one that was a smaller diameter. Fred @ Centurion Tools referred me to Keo Cutters. They have a large number of broach mills that will work. AND give us about 20 choices of slot width. (and at 1/3 the price)

BTW, I slotted 100 boards with a #199 Dremel bit. (or 4 or 5)

[Gary Campbell]

Like this: