Z adjuster bracket

[loriny]

Somewhere, I think in somebody's photo bucket or something I remember seeing a triangular bracket with some form af adjuster to tweak the Z. If anyone remembers seeing this or it is theirs I would appreciate seeing the picture again. This was on a PRT.
Lorin

[curtiss]

The one I saw a while back had an 8" long angle iron on each side of the z, with two locking set screws on each angle iron to micro-adjust the vertical... sort of like a pool table.

[knight_toolworks]

I made me a set out of aluminum angle iron just bolted together. I did not have the time to screw around with steel. I will make a new set when I get around to it but they work great and it made it dirt easy to get my machine back to square.