LesLinton
12-10-2010, 12:13 AM
Well, my plenum board is glued down and I'm ready to cut all my little grooves.
I've noticed many people showing their plenums that have squares pop out and I had the same problems when my machine was last running.
I'm wondering if a different approach will work as well and thought I would toss this out to get some opinions.
I want to try this with a v-bit. 3/4" diameter. 3/8" depth on the v and another 1/8" straight.
Take a look at the pdf. 5 zones. I am MOST interested in why this method might not work. It seems like I should have no problems, but that's why I'm asking.
Couldn't get the file small enough with everything so I cut off the bottom two 24 x 48 sections.
Oh, I'm using my Fein for vac.
Les
I've noticed many people showing their plenums that have squares pop out and I had the same problems when my machine was last running.
I'm wondering if a different approach will work as well and thought I would toss this out to get some opinions.
I want to try this with a v-bit. 3/4" diameter. 3/8" depth on the v and another 1/8" straight.
Take a look at the pdf. 5 zones. I am MOST interested in why this method might not work. It seems like I should have no problems, but that's why I'm asking.
Couldn't get the file small enough with everything so I cut off the bottom two 24 x 48 sections.
Oh, I'm using my Fein for vac.
Les