loriny
12-13-2010, 04:25 PM
Any idea what might cause a problem with Z shift cutting cabinet parts. I have been succesfully zeroing to the table for all my cutting- 5/8 and 3/4 sheet goods. Now when cutting a job the 5/8 material is going fine. I ran a sheet of 3/4 maple (thickness set to .735) and it seems like the software is offsetting only for 5/8. My dadoes are 1/2 deep rather than 3/8 and the tenons are 1/4". All the through cuts plowed through into my spoil board by it looks like 1/8 or so. I checked my Z zero height and it hasn't changed.
Lorin
Lorin