What is the command SC?

[arnold]

I find on my cu butt files from Aspire the command SC followed by 1,1 or 1,0 but I can not find it listed in the command listings.

[zeykr]

SC is clear user variables. Are you sure you're not seeing SO,1,1 which is set output 1 to on and SO,1,0 which is set output 1 off. This is normally used to start router or spindle.

[Gary Campbell]

Ken is partially correct. [S] [L] is clear user variables. You probably have the [S] [O] which does turn a spindle or router on (or off depending on 0 or 1).

[S] [C] may be a legacy command that set to single step mode. Hasnt been used in a long time

[adrianm]

If you're looking at the file in the ShopBot editor you might find that what you think is SC is in fact SO.

The font used in the editor makes a capital O look like a capital C.

AS Gary says the SO command is used to switch the outputs. SO,1,1 usually turns the spindle on and SO,1,0 turns it off.

[arnold]

Thanks all-when I look closer is see the very light part of the O. Thanks all