Auto 0 z-axis file

[tomp]

I burst my PRT controller and switch to Geckodrive G540 and using Mach3. I would like to have a program for "Auto 0 Z axis" as shopbot use C2 program. Have somebody created one for Mach3 or other file to 0 Z please share me one. I like the Z go down and touch plate, back up and down touch again then it go back home like most of the shopbot use. Please help,:confused:

[srwtlc]

Tom,

I made one a few years back that many are using or using a variant of. The best way to do it is to have it built into the screenset that you are using. If you know how to do that, I can send you the file to use, or I can set it up for you. Let me know. Email in profile.

There are a number of post on the Mach3 and CNCzone forums showing how to set one up to, but to get it built into your screenset can be a challenge if your not familiar with it.

Scott

[tomp]

Scott,
First of all, thank you very much for your help. I've never built into screenset before. Please help.

Tom,

[srwtlc]

Tom,

Send me an email and I'll get back to you asking some initial questions and we'll get ya set up.

Click on my name/picture and my email address it under "About me". Or you can PM me from there too.

Scott

[tomp]

Scott,
PM was sent,
Tom,