brian
03-07-2011, 04:23 PM
I've been asked to cut some .06 polystyrene for a spray paint decal.
I've tried a drag knife as a test piece and had limited success.After tracing the same lines four times I still had to use a razor knife to cut the piece free.
Has anyone used a router bit to cut this material?
I was thinking a .06 bit used with a pressure foot might work.
Brian
I've tried a drag knife as a test piece and had limited success.After tracing the same lines four times I still had to use a razor knife to cut the piece free.
Has anyone used a router bit to cut this material?
I was thinking a .06 bit used with a pressure foot might work.
Brian