knight_toolworks
03-12-2011, 11:08 PM
I got tired of my knock together stands that I got from shopbot files. they were wobbly and we had a munch of mince and they peed on them. Plus my monitor hardly fit and I wanted to go with two monitors.
So I made this table out of marine mahogany plywood. I for got I had some sepelle plywood that would have let me use one piece for the top.
well anyway I spent a whole 2.5 hours on this sucker. I forgot the bottom braces so I had to screw them on. otherwise all the joints are glue and pressure fit. This may be the last time the top is seen. I just made fun dogbones to connect the two pieces of the top simple half laps to make the legs since the material was not large enough.
http://i154.photobucket.com/albums/s266/knighttoolworks/photo1-18.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/photo5-3.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/photo4-2.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/photo3-4.jpg
So I made this table out of marine mahogany plywood. I for got I had some sepelle plywood that would have let me use one piece for the top.
well anyway I spent a whole 2.5 hours on this sucker. I forgot the bottom braces so I had to screw them on. otherwise all the joints are glue and pressure fit. This may be the last time the top is seen. I just made fun dogbones to connect the two pieces of the top simple half laps to make the legs since the material was not large enough.
http://i154.photobucket.com/albums/s266/knighttoolworks/photo1-18.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/photo5-3.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/photo4-2.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/photo3-4.jpg