Software Lock Up PRS

[majohnson]

Anyone else have a problem with the computer locking up when you stop a cut. It happens frequently, the only way is to force quit the SB3 software and the router dosen't retract. I have the most recent update install.

Are any firmware updates. Reading the notes along with the update, says it included in the update.

PRS Standard

[knight_toolworks]

I get it randomly on my prt. though usually when I hit k after a jog. but computer upgrades make it less and less often.

[chunkstyle]

Yes,
I get it to, like if I have a break between bits and go get a cup of coffee or I let the spindle run to warm it up and it runs long enuff to shut down automatically (I think I was told 15 minutes) the SB3 will be vapor locked. Have to do a hard boot to the computer. Sometimes it has required rebooting the computer twice and turning off and back on the control box to get things up and running again.

[majohnson]

Looking at the configuration of my laptop, I have 2gb of memory and when I'm cutting, I not running a bunch of programs in the background. So computer wise, I am not taxing my system.