PDA

View Full Version : Fein 9.77.25 Vac


matney_models
03-29-2011, 03:11 AM
Last time time I use this vac it run fine. And now it will not run. Is there a reset button or some thing. This vac only has about 1 hr on it.
matney_models
03-29-2011, 03:13 AM
This is a Turbo III
bill_l
03-29-2011, 06:52 AM
Kevin,

There are two switches on the front of the vac. One on/off and one to enable this function when an auxiliary tool is plugged into the vac. Check to see if you accidentally turned this switch on by mistake.

Bill
matney_models
03-29-2011, 01:20 PM
Tried it both ways, no luck. I do have 120volts to the plug.
Brady Watson
03-29-2011, 02:04 PM
Assuming it is no longer under warranty...Unplug it and pull the head off. Check those switches for continuity. One of them could be bad.

Smell the motor (yes I said smell it) sniffing for traces of magic smoke leakage. You didn't smell the motor burn up or anything did you?

-B
matney_models
03-29-2011, 03:52 PM
It was the switch. It was not in the holder right from the factory from the get go.It even took me a few times to get it right. But all work now.
Thanks