View Full Version : My Bot started acting strangely today…
steve_g
04-19-2011, 11:08 PM
My Bot started acting strangely today… or at least my computer did. Every time I try to open a file the “setup” procedure starts running. I have to go through the whole thing each time before it will let me run the file. Has anyone else had this situation and solved it?
Steve
Brady Watson
04-20-2011, 07:51 AM
Take a look at the post processor you selected. If you are running an older version of SB3 and your SBP has TS commands in it, it will call the Tools-->Setup screen to pop up.
-B
steve_g
04-20-2011, 09:15 AM
It was the “TS” command all right! I was using the tool paths generated directly by PartWorks3D (no postprocessor selected), without first importing them into PW3 for incorporation into a larger project, something I guess I’d never done before.
Thanks
Steve
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.