Rotating Material in PW 3D

[taskins]

Is there a way to rotate the material in the Z axis in PW 3D? I have a design imported from DrafeSight that is only 2" thick but the material block in PW3D is 3.6, because of the rotation in the z axis.

I can't figure out how to rotate the material in the Z block of the material so that it is centered- or pushed to the top or bottom. Any ideas?

Thanks

Tim Askins

[Brady Watson]

Rotating increments less than 90 degrees in PW3D is not possible. You will have to do this in your CAD program and re-save the 3D file. PW3D reads the normals/orientation from your CAD.

-B

[taskins]

Thanks Brady- as they say...back to the drawing board.

May be a nice feature for a future release?

Tim