nat_wheatley
07-25-2011, 05:01 PM
I've had an odd issue several times over the last few weeks when I'm sending a file to my machine to cut (from the SB Link). The file begins, the spindle travels to about the middle of the table, then stops abruptly, with no error message. All commands dissappear from the command console screen. Several of the inputs do stay on, as my vacuum table and dust collector are tied into relays, and those continue to run.
Typically after this happens I 'Write to Shopbot' again, and the file runs fine. Anyone know what might be going on? Thanks.
Typically after this happens I 'Write to Shopbot' again, and the file runs fine. Anyone know what might be going on? Thanks.