PDA

View Full Version : Outside Corners



nat_wheatley
08-18-2011, 05:58 PM
Does the slow corner speed control the speed at outside corners? I'm cutting some parts at 6ips, 12.5K RPMs, with the SCS set at 90%, and the outside corners are cutting painfully slowly (bit screaming at corners). Rectangular parts/square corners. I should know this by now, not clear what the issue is. Thanks.

dlcw
08-18-2011, 09:04 PM
My machine always screams a little at corners because of the feed rate slow down. It hums along nicely on the straight-aways though.