toddho
11-04-2011, 11:25 AM
Hey guys, I blew away my some files while upgrading to a newer version of Shopbot software. These files were modified by me (can't remember exactly how) but I got the info on how to modify them SOMEWHERE on these forums.
There is a thread out there that goes through how to swap the X and Y axis so the tool orientation is when you are standing in front of the table and not the "end" of the tool. I think that is was a little more involved than what is in the manual. I have a buddy and it just makes more sense to me to have the bridge be the X axis and the table the Y axis.
Can anyone point me to that thread? I have searched and searched and can't find it.
Thanks
Todd
There is a thread out there that goes through how to swap the X and Y axis so the tool orientation is when you are standing in front of the table and not the "end" of the tool. I think that is was a little more involved than what is in the manual. I have a buddy and it just makes more sense to me to have the bridge be the X axis and the table the Y axis.
Can anyone point me to that thread? I have searched and searched and can't find it.
Thanks
Todd