RPM dialog box

[C. Pile]

Hi All,

I am curious if anyone knows how to view the RPM dialog box. Normally it pops up when I start the ShopBot 3 software but it doesn't anymore. I've looked through the drop down menus but can't figure out how to get it back.

thanks,
Cody

[dana_swift]

The "TR" command brings it back.

D

[C. Pile]

thank you this is what I was looking for!

[srwtlc]

Once it's up, if you click on "RPM", a fill-in sheet will pop up and in that, put a "1" in "Start when SB3 starts".

[Hobodog2]

Does use of the RPM Dialog Box require a special cable between the spindle control box (in my case the Delta box) and the ShopBot control box?

[srwtlc]

Yes, it requires one of these from ShopBot (scroll down to 'Spindle Control Boards). Goes from the computer to the VFD

http://www.shopbottools.com/mProducts/spindles.htm

[penman]

Hi Scott,
that was a helpful bit of information thank you. I have always had to display my spindle speed by going to tools----spindle control for it to show up, but with that wee gem you passed on it now opens automatically. Thanks.

Cheers and regards,

Roger.