How do I reset error suppression in Part Wizard?

[jdervin]

Note that this is a question pertaining to Part Wizard and not PartWorks...

I was attempting to calculate a toolpath and received an error code that identified the start point of the offending vector by its X/Y location. Kind of convenient, huh? Well, at the bottom of the window, there was a question or check box about suppressing further error messages. While attempting to move the cursor to change the setting to "no", my finger twitched on the touch pad, accepting the input as a "yes".

Anyone know of a way to reset this in Part Wizard?

[bleeth]

John:
I'm pretty sure that message is automatically reset when you close and then re-open the project. I'm sure it is when you start or open a different project.

[jdervin]

Yep, you're right. Re-opened the project and the message was available again. Thanks.