myxpykalix
02-25-2009, 02:57 PM
I have an idea of taking a round table i'm making that might be 4 ft diameter that would have probably a 2+ inch skirt around it and carving some type of design on the face around the entire circumference.
That would entail moving the indexer to a location where the tabletop could be mounted so it would rotate under the gantry but i'm wondering if there would need to be any different type of gearing due to the larger circumference or is it as simple as making the file the same size as the circumference of the skirt?
That would entail moving the indexer to a location where the tabletop could be mounted so it would rotate under the gantry but i'm wondering if there would need to be any different type of gearing due to the larger circumference or is it as simple as making the file the same size as the circumference of the skirt?