lee_pruitt
05-02-2009, 08:24 PM
I just received my indexer and a new Gecko 203v driver. I installed the unit and nothing happened. I swapped out another driver a 202 from inside my control box - It worked just fine.
Except I type MB 360 and it rotates about 320 degrees. What am I doing wrong ? Or is this because Shotbot set the indexer up using a 203 driver ?
Anyone have any ideas.
Unfortunately no instructions were shipped with the indexer. So I am using my original shopbot manual.
Thanks
Except I type MB 360 and it rotates about 320 degrees. What am I doing wrong ? Or is this because Shotbot set the indexer up using a 203 driver ?
Anyone have any ideas.
Unfortunately no instructions were shipped with the indexer. So I am using my original shopbot manual.
Thanks