10 x 5 vacuum/plenum artcam drawings

[bob_lofthouse]

Hi all,

I'm thinking of cutting a fresh vacuum bed.

I already have the 10 x 5 .sbp cutting files but does anyone have the 10 x 5 partswizard .art files.....

I'm looking to tweak them a little bit...

[Brady Watson]

Robert,
Here's a grid I made in PW for a customer with a 5X10 table. It was drawn up to be cut .375 deep in .75" material. His table was a true 48X120, so if you are using standard 49"X121" material (or mm equiv) be sure to move your 0,0 point up 1/2 the extra width, height to center it in the table.

This file is not the cutting file, but a PW2.ART file, plus an EPS version of the same file. Just select the vectors and do a Machine Along Vector strategy. The offsets are setup for a 1/2" / 13mm bit.

-Brady



5X10Grid.zip (http://www.talkshopbot.com/forum/messages/7/5X10Grid-10913.zip) (5.1 k)