View Full Version : latest project
cowboy1296
04-17-2012, 06:57 PM
i learn more with each cutting. this is the latest
Ajcoholic
04-17-2012, 08:04 PM
What type of bit did you use for that? How did it take to carve?
Looks very nice!
Andrew
cowboy1296
04-17-2012, 08:30 PM
the finish tool path was done with an 1/8 of an inch precise tappered bit. the speed was set at 3 inch per second and 7 percent stepover. it took 4 hour and 30 minutes. done in alder, very little fuzzies if any. i forget how long the roughing took... i am sure i did it with a quarter inch bit.
i did a roundover on the profile.
cowboy1296
04-17-2012, 08:32 PM
ps thanks, forgot to acknowledge your comment.
danhamm
04-17-2012, 10:30 PM
Way to go Rick, nice....
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.