Files cutting twice

[phil_o]

I've had this problem a few times. Yesterday I had to run a 3D cut file twice. After completing the cut it went back to the beginning of the cut and started all over again. When I ran the same cut file a second time on another piece of wood it did not run twice.
I have SB 3.5.18

Phil

[garyc]

Phil...
Attach the SBP file with a "txt" file extension so we can take a look to see what is happening

[phil_o]

I've attached the file. It has a SBP extension. I don't know what you might see. I ran it in Aspire preview and it looked fine. This isn't the first time this has occurred.

[khaos]

I've attached the file. It has a SBP extension. I don't know what you might see. I ran it in Aspire preview and it looked fine. This isn't the first time this has occurred.

Are you sure the "repetitions" box isn't getting an inadvertant boost? That ALT-L can be a [female dog] ...

[garyc]

Phil...
Dont see any attachments. I was going to look in the file to see if there was anything that might make the file repeat. This would eliminate a design or postP problem. The other causes would be settings at the machine. Like Joe says, repetitions could be one cause.

[phil_o]

Apparently the file is too large -1,498 KB.

Khos - If I did do the ALT L it was inadvertent. Don't know what else it could be.

[khaos]

Other than that i have no idea why it would... :confused:

[garyc]

Unless that (older) version retained the settings from the last use......?

[phil_o]

The problem occurred on the first run of the cut file. It ran as expected the 2nd time I used this cut file.

Phil