tr command

[jerry_stanek]

when using the Vectric post processor (Shopbot_arc_ inch_spindle_control.pp) is the TR command supposed to bring up the TR window or do you have to type TR in before you load the cut file.

[adrianm]

When the RPM window (TR) is displayed if you click the mouse in the top left of the window you will get an options sheet come up where you can set it to start automatically whenever you load the SB3 software.

[srwtlc]

It is supposed to open with a TR in a file if it's not already open. I thought it was fixed, but perhaps not. I have had mine set as Adrian stated so I never noticed whether it did or didn't. It doesn't work in the beta release either. What version are you using Jerry?

[jerry_stanek]

I an running the Beta version.

[jerry_stanek]

Thanks guys that did the trick. Still having some small problems after I run the warmup file the spindle control locks up and won't change until I shut down sb3 and restart it that is not to much trouble though.