nat_wheatley
06-14-2012, 08:42 PM
The scenario is that I'll nest a job, then send the job to the machine. It goes through the first few lines of code, bit drops down to the safe height, then the program cuts out/ disappears from the console/ ends.
It's also losing position at this point. If I resend the file to the machine, it typically works, but leaves about a 1/4" skin on all parts. (Also appears to lose X position as well).
I'm not sure what's going on, but it's resulted in a few sheets of parts going into the dumpster over the last several weeks, so I need to clear it up...
It's also losing position at this point. If I resend the file to the machine, it typically works, but leaves about a 1/4" skin on all parts. (Also appears to lose X position as well).
I'm not sure what's going on, but it's resulted in a few sheets of parts going into the dumpster over the last several weeks, so I need to clear it up...