bahed
10-21-2007, 02:48 AM
I am attempting to wire my 5 hp, single phase Colombo spindle up and I am not finding what I am looking for in either the included or on-line (Colombo Spindle) documentation.
For example: I have a brown insulated wire (black and brown wire inside) that is hooked up correctly in the VFD, but I can not find the matching FWD or DCM terminals inside of the Control Box as directed.
Secondly, it mentions to run my black wire (4-wire power chord) from my VFD to my Control Box - now I know better. This should be going into a 40 amp 2-pole circuit - right ? I'm starting to doubt myself here.
Lastly, I have 3 separate grey insulated wires coming from my motors along with the Wago clips. One has red tape on it (black-brown-blue wires inside), one has blue tape (black-brown-blue wires inside) and the third has no tape (green-black-red wires inside). Ok, I realize that they are related to the motors but where do they go ? The documentation says nothing about them, unless the one with no colored tape is a proximity switch.
I would wait until Monday and talk to tech support, but tomorrow (Sunday) would be SO NICE to get this thing wired up.
Any help ?
For example: I have a brown insulated wire (black and brown wire inside) that is hooked up correctly in the VFD, but I can not find the matching FWD or DCM terminals inside of the Control Box as directed.
Secondly, it mentions to run my black wire (4-wire power chord) from my VFD to my Control Box - now I know better. This should be going into a 40 amp 2-pole circuit - right ? I'm starting to doubt myself here.
Lastly, I have 3 separate grey insulated wires coming from my motors along with the Wago clips. One has red tape on it (black-brown-blue wires inside), one has blue tape (black-brown-blue wires inside) and the third has no tape (green-black-red wires inside). Ok, I realize that they are related to the motors but where do they go ? The documentation says nothing about them, unless the one with no colored tape is a proximity switch.
I would wait until Monday and talk to tech support, but tomorrow (Sunday) would be SO NICE to get this thing wired up.
Any help ?