Router Bit to cut coroplast

[David Iannone]

What bit would you recomend to cut 1/8", 1/4" and 1/2" thick corplast without getting all the fuzzies on them. Is that possible? If so, part numbers please. I have to cut some coro shapes next week 1/8" thick. But have ideas for making christmas yard ornaments and reindeers for christmas this year out of 1/2" white coro. ( I am planning this year for our yard display) We have to beat the neighbor's this year...LOL :)

Dave

[rb99]

Have you tried a 2 flute straight bit?

[knight_toolworks]

I tested a new 0-flute upcut from onsrud and it cut well with little if any of those flaps I did not expect that clean of a cut.

[David Iannone]

Steve,
Can you tell me the onsrud bit number?
Thanks,
Dave

[knight_toolworks]

Not sure if it matters the ones I am using re discontinued as I get them cheap from onsrud on ebay.

[knight_toolworks]

Here are the cuts with a 65-023e 0-flute

http://i154.photobucket.com/albums/s266/knighttoolworks/posting/B0542AB2.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/posting/E8A413CF.jpg