View Full Version : Router Bit to cut coroplast
David Iannone
06-28-2012, 02:37 AM
What bit would you recomend to cut 1/8", 1/4" and 1/2" thick corplast without getting all the fuzzies on them. Is that possible? If so, part numbers please. I have to cut some coro shapes next week 1/8" thick. But have ideas for making christmas yard ornaments and reindeers for christmas this year out of 1/2" white coro. ( I am planning this year for our yard display) We have to beat the neighbor's this year...LOL :)
Dave
Have you tried a 2 flute straight bit?
knight_toolworks
12-02-2012, 01:15 PM
I tested a new 0-flute upcut from onsrud and it cut well with little if any of those flaps I did not expect that clean of a cut.
David Iannone
12-21-2012, 04:45 PM
Steve,
Can you tell me the onsrud bit number?
Thanks,
Dave
knight_toolworks
12-22-2012, 09:12 PM
Not sure if it matters the ones I am using re discontinued as I get them cheap from onsrud on ebay.
knight_toolworks
12-27-2012, 06:42 PM
Here are the cuts with a 65-023e 0-flute
http://i154.photobucket.com/albums/s266/knighttoolworks/posting/B0542AB2.jpg
http://i154.photobucket.com/albums/s266/knighttoolworks/posting/E8A413CF.jpg
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.