What is the fastest speed?

[signtist]

I have a large project that is woodgrain texture into HDU.
The feed speed I'm using is 6 ips and the Z is set at 2 ips.
What is the fastest I can set this machine to?
I'll have about 6 full sheets to texture. Time is everything!

[Brady Watson]

You can try 6,6 but expect some hard moves on the machine. Tune your VR slow corner speed to 65 and 3D threshold to 150 or 200.

If 6,6 is too coarse, try 8,3. Do not run these speeds on a Standard. I am assuming it is an Alpha.

-B