New to site First sign project.

[Dmaff06]

Hey guys my names dan, I started researching sign making online and found this site and went no further. The help y'all give to eachother and the suggestions are awesome and I could not have gotten as far as I have without reading these forums.

I'm currently working on a set of signs for a store here in Delaware, they are foam board insulation. Carved letters. The sizes are one 8foot by 2ft and two 2ft by 1ft.

I used a mix of "concrete fortifier and water puddy" to coat the signs which is the stage where I am at currently. I will be posting photographs of my project shortly after this post.

[Dmaff06]

Here are some photos of my current project.

[bleeth]

Well, it looks like you are starting off by getting some good "Experience"
(Sorry-It was just too easy!!-Keep it up. You also may want to check out the 3d sign forum.

[Dmaff06]

Haha thanks it's def a learning process.

Lots of mistakes and issues I've had to work around. Thak younformthenother link I'll check it out too.

[letterman7]

Where are you in Delaware, Daniel? If you want some hands-on practical advice/demos, just give me a PM. I'm not too far from Wilmington in Chester County, PA.

[gene]

Have you looked at the site 3dsignforum.com

[Dmaff06]

Than for the comments guys. I did finish this sign up I'll be posting photos tonight of the rest of the process and the installed location.

I will def pm you this week and try to work Somthing out


I did check out the 3d forum. I applied for a account there tho I haven't received a confirmation email.

[mjindustry]

Than for the comments guys. I did finish this sign up I'll be posting photos tonight of the rest of the process and the installed location.

I will def pm you this week and try to work Somthing out


I did check out the 3d forum. I applied for a account there tho I haven't received a confirmation email.

Daniel. You have been approved already. You are good to go.