mjindustry
03-01-2010, 04:41 PM
Hi,
When I first setup my prt96 it seemed pretty level. That was about a year ago. I don't remember adjusting the leveling feet at all. Recently I had a problem where I was getting cut errors up near one side of my table on the top end of my Y. Well I check that corner seems low (not even a 1/4 bubble over 4ft, but still). Could this cause problems though?
I went to adjust the leveler and it is soo tight on the bottom part. Any advice for working with the levelers?
TIA for any assistance.
When I first setup my prt96 it seemed pretty level. That was about a year ago. I don't remember adjusting the leveling feet at all. Recently I had a problem where I was getting cut errors up near one side of my table on the top end of my Y. Well I check that corner seems low (not even a 1/4 bubble over 4ft, but still). Could this cause problems though?
I went to adjust the leveler and it is soo tight on the bottom part. Any advice for working with the levelers?
TIA for any assistance.