garyc
10-23-2012, 08:58 PM
From the Thermwood website: http://www.thermwood.com/updates_shopbot_link.htm
Items included in this update
•Trimming routine for the pin area to square the sheet not cutting enough for full sheet flips with certain tool diameters and trim values. (FIXED)
•Depth not correct for chain cuts from max penetration operations. (FIXED)
•Holes that come close to touching from both sides of the part getting cut through when going to the Load screen and back in metric. (FIXED)
•Flip operations not printing or graphically displaying properly when full sheet flips are used. (FIXED)
•Dovetail construction failing with certain tool diameters and tabbing. (FIXED)
•Failure to cut dados without warning occuring when select tool tolerance is set too large resulting in tool not being able to fit. (FIXED)
•Part not getting perimeter cut all the way through when the perimeter has arcs and is not a double pass part. (FIXED)
Items included in this update
•Trimming routine for the pin area to square the sheet not cutting enough for full sheet flips with certain tool diameters and trim values. (FIXED)
•Depth not correct for chain cuts from max penetration operations. (FIXED)
•Holes that come close to touching from both sides of the part getting cut through when going to the Load screen and back in metric. (FIXED)
•Flip operations not printing or graphically displaying properly when full sheet flips are used. (FIXED)
•Dovetail construction failing with certain tool diameters and tabbing. (FIXED)
•Failure to cut dados without warning occuring when select tool tolerance is set too large resulting in tool not being able to fit. (FIXED)
•Part not getting perimeter cut all the way through when the perimeter has arcs and is not a double pass part. (FIXED)