Shopbot table surfacer tool

[chuckster]

I cant run the table surfacer anymore, it says it cannot find the shopbot.exe for that tool. Any suggestions on how to get it to work again?

[chuckster]

45 views......no replies? Please help me figure this out!

[garyc]

Chuck...
Setup a PartWorks file to surface your table. It gives better control over the surfacing and doesnt force you into that 4 sided area clear. Surfacing in the X direction results in a much smoother table.

Or... Command [C][R] and use the fill in sheet

[chuckster]

Thank you, Gary! One would think as long as I have been doing this I could have figured that out!:cool: