Web Training 11/14/12 PARTWORKS/ASPIRE DRAWING TIPS

[TJ]

If you have forgotten some basic Partworks/Aspire drawing techniques or you are looking to speed up your drawing time within the software this training will be great for you. Spend two hours navigating and drawing within the software. Tips/tricks will include layout lines, mirroring, software navigation, node editing and much more.

1:00pm Eastern Time Zone. Wednesday 11/14/12. Run time appx. 2.5 hours.

1. Please join my meeting.
https://global.gotomeeting.com/join/932859749

2. Use your microphone and speakers (VoIP) - a headset is recommended. Or, call in using your telephone.

Dial +1 (213) 493-0614
Access Code: 932-859-749
Audio PIN: Shown after joining the meeting

Meeting ID: 932-859-749

[dougo]

Thanks for the heads up.

[gerryv]

Unfortunately, can't make it. Sure hope you'll do this one again soon. :)

[TJ]

FYI.. All of these are recorded and posted for future viewing, look under WebClasses:

http://www.shopbottools.com/mSupport/tutorials.htm

This one will be posted by early next week.

[TJ]

Here is the URL for the training from yesterday. Please feel free to send me an Email with any idea for future trainings.

http://www.shopbottools.com/Training/Videos/DrawingTips.wmv

[jhedlund58]

TJ... i wood like to thank u for taking the time to do the web training. I was watching the one on chip calculator and notice that my spindle wasn't changing RPM's automatically with the aspire generated code... not sure when my problem started... but called shopbot and all is fine in hobby land.

Thank you
Jeff

[kevin]

Thanks for taping I was busy yesterday thanks
Kevin