Z-Zero Plate Installation?

[joewino]

Where can I find information on how to install our Z-Zero Plate and how to wire everything up?

[kerrazy]

Once again ken, have a look in your ShopBot manual, under accessories, If this machine was used and the previous owner did not insert the documentation in there check out this link http://shopbottools.com/files/SBD122_040809PRTalpha,Wiring%20the.pdf (http://shopbottools.com/files/SBD122_040809PRTalpha%2CWiring%20the.pdf)


I know it is the Alpha, and hopefully this is what you are using, but if not the PRT is a similar hookup to the input blocks Page 8 of the PDF

Dale

[joewino]

Thanks Dale...there it was all the time and I just overlooked it. Must have been one of those Senior Moments.

[kerrazy]

Sorry Ray,
Did not mean to be a smart ass, My apologies... Hope all is well.
Dale

[joewino]

No apology needed Dale - I didn't find anything you said to be offensive.

We are about ready to see what this ShopBot can do. Lately, we have been swamped with sign work and put the assembly of the router on the back burner.

[frank_hav]

Dale,

FYI I had to switch the plate/clip wires on my new Alpha to make the plate work. When I hooked up according to the book the ground was on the wrong side.(When I put the clip on the bit it showed a gound instead of when the plate touched the bit.) Not a big deal but you may the same thing.

Frank