sign

[rej]

just finished.

[kurt_rose]

Beautiful sign Rob. I'm really looking forward to the camp in May now! I'm leaning towards also attending the class on the monument signs as well.:D Looking forward to meeting you.

[Rick W]

Wow, nice Rob!!!

What is it made of?

I like it!!!

Good finish too!!

NICE

Rik

[kartracer63]

Awesome job Rob!

What is the name of that font?

[bob_reda]

Great sign.

Bob

[rej]

thanks for the comments.
material is 20# precision board, 2" thick, 2 pieces for total of 4 inches.

font is raptor from here: http://artandsignstudio.com/fontmenu.html
I built the file in aspire as one piece - 2" thick, then applied the back 2 inches.
rust on the band is paint only.
is this stuff fun or what?

with a new shop and a 8x28 wall to fill up, samples signs will be cut all winter.

rob

[myxpykalix]

Nice work Robert..:D

[gene]

Very Good . is it cut with 1 bit or are different parts cut with different bits? I would not even know where to start :confused:

[rej]

rough cut was done with a .50 end mill.
finish cut was a .25 ball nose.
the bottom text was the gone over again with a 1/8 ballnose.
finally, it was cut out of the blank with a 1/4 end mill.

i think the total time was about 11 hours, plus or minus an hour.
design time was about 2 hours.

paint time was around 20 hours.

rob

[cowboy1296]

Looking forward to the school. There is still so much for me to learn. PS it looks as if i will be buying a trailer while i am out there based on your recomendation in case you get any kudos for that.